Cisco 642-457 Exam Collection, High Success Rate Cisco 642-457 Demos On Sale

No doubt, Cisco 642-457 exam is worth challenging task but you should not feel hesitant against the confronting difficulties. Get a complete hold on Cisco 642-457 exam syllabus through Flydumps training and boost up your skills.What’s more,all the brain dumps are the latest.

QUESTION 49

A. Using Network Address Translation, any host on the DMZ1 subnet (172.16.1.0) will be translated to a mapped address on the outside interface of 192.168.1.11
B. Using port address translation, DMZ2 host 172.16.10.2 will be translated on DMZ1 to IP address
172.16.1.22 with a dynamically assigned port address
C. Using Network Address Translation, host 10.0.1.10 on the inside network will be dynamically translated to a mapped address from the address pool of 192.168.1.20 to 192.168.1.94
D. Using port address translation, outside host 192.168.1.10 with a dynamically assigned port address will be translated to 10.0.1.11 on the inside interface

Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 50
When troubleshooting poor network performance, which two symptoms would typically be associated with a network layer problem? (Choose two.)
A. Packet loss is more than 30 percent
B. There is excessive broadcast traffic
C. There are excessive CRC errors
D. Pings succeed only part of the time
E. Slips are detected on WAN interfaces
F. ARP requests are timing out
Correct Answer: AD Section: (none) Explanation

Explanation/Reference:
QUESTION 51
Which three statements are correct about the IEEE 802.3af Power over Ethernet standard? (Choose three.)
A. It defines a port that acts as a power source to be a PSE
B. It defines a powered device to be a PDE
C. It defines how a powered device is detected
D. It defines three methods of delivering Power over Ethernet to the discovered powered device
E. It describes five power classes to which a device may belong
F. It defines power class 0 as being reserved for future use

Correct Answer: ACE Section: (none) Explanation
Explanation/Reference:
QUESTION 52
You have just configured and enabled the Cisco IOS Firewall feature set from a remote location using the Cisco Router and Security Device Manager (SDM) Firewall wizard. You later want to double-check your configuration using Cisco SDM. However, you find that you can no longer connect to the Cisco IOS Firewall using Cisco SDM. What is the probable cause of this failure?
A. You must additionally specify the Cisco SDM management port number to gain access when the configuration has been applied
B. You have not generated an RSA key pair between the host and device to allow secure access via Cisco SDM
C. You have been locked out via access lists that have been applied to the router as a result of your Cisco SDM configuration
D. You must specify the host IP address of Cisco SDM in the Configuration panel for allowed management connections.

Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 53
When using Cisco Router and Security Device Manager (SDM) to configure IPS, what must you do first before you can select Configure > Signature to edit any signatures?
A. Select Configure > Global Settings to enable IPS globally on the router
B. Select Configure > Global Settings to disable the Failed Closed option
C. Select Configure > Global Settings to point Cisco SDM to the ips.tar file in the router Flash memory
D. Select Configure > Rules to create the inbound and/or outbound filter to determine which traffic will be scanned by IPS
E. Select Configure > Rules to enable an interface for inbound and/or outbound IPS
Correct Answer: E Section: (none)

Explanation Explanation/Reference:
QUESTION 54

A. Switch A sends PVST+ BPDUs of VLAN 2 (to the SSTP address that is flooded by Switch B) towards Switch C. Switch C will put port C-B into a type-inconsistent state, which prevents the loop
B. Switch B sends PVST+ BPDUs of VLAN 1 (to the SSTP address that is flooded by Switch A) towards Switch C. Switch C will put port C-B into a type-inconsistent state, which prevents the loop
C. Switch C sends PVST+ BPDUs of VLAN 2 (to the SSTP address that is flooded by Switch B) towards Switch C. Switch A will put port C-B into a type-inconsistent state, which prevents the loop
D. Switch A sends PVST+ BPDUs of VLAN 1 (to the SSTP address that is flooded by Switch B) towards Switch B. Switch A will put port C-B into a type-inconsistent state, which prevents the loop

Correct Answer: A Section: (none) Explanation
Explanation/Reference:
QUESTION 55
In an infrastructure based on a wireless advanced feature set using lightweight access points, by which method is a rogue contained?
A. The WCS sends excessive traffic to the rogue, thus overloading the access point
B. The rogue MAC address is used to spoof broadcast deassociation packets
C. The rogue MAC address is used to spoof broadcast deauthentication packets
D. The WCS sends out excessive signals on the same channel when the rogue is detected

Correct Answer: C Section: (none) Explanation
Explanation/Reference:
QUESTION 56
OSPF routes are being redistributed into EIGRP but they are not showing up in the routing table. What are two possible causes? (Choose two.)
A. CEF has not been enabled
B. Synchronization has been turned off
C. Incorrect distribute lists have been configured
D. No default metric has been configured for EIGRP
E. The ip classless command is missing
F. There are mismatched autonomous system numbers

Correct Answer: CD Section: (none) Explanation
Explanation/Reference:
QUESTION 57

A. The IP address that is used for the router ID must be reachable
B. Router 1 is the designated router because it has the lowest configured IP address
C. Router 1 is the designated router because it has the highest configured loopback address
D. If Router 1 had a PRI of 0, it could not be a designated router or a backup designated router
E. Router 1 has had its ID manually configured by using the router-ID command

Correct Answer: CD Section: (none) Explanation
Explanation/Reference:
QUESTION 58
How many active VPN clients are currently to the 1841 ISR router?
A. 0
B. 1
C. 2
D. 3
E. 4
F. 5
G. 6
H. 7
I. 8

Correct Answer: B Section: (none) Explanation
Explanation/Reference:

You will pass your Cisco 642-457 exam GUARANTEED using our accurate Cisco 642-457 practice questions and answers PDF&VCE dumps. Flydumps Cisco 642-457 exam dumps will help you not only pass in the first try, but also save your valuable time. Give your career a boost and start earning your Cisco certification today!